Wednesday, May 6, 2009

Parts Ordered #1 for engine rebuild


Below is my first parts order for my engine, which I ordered from Scooters Originali.  I did not include the quantities below.

Spacer, Seal Retainer - Mag

Screw, DriveSide Oil Seal Plate

Oil Throw Washer A16

Deep Nut - 8mm

Kickstart Rubber Bumpstop

Cone Engine Bolt - Li Special/TV/SX/GP

Washer-Engine Bumpstop Rubber

Engine Rubber Bumpstop

RIV Bearing- Rear Hub Bearing RIV

Kickstart Pad - Ser 3 - Black

Spacer, Bearing Spacer - Mag

Washer, Split Lock - 7mm

Flange - Rear Hub Seal Holding Plate

Distance Nut Spacing Cylinder Cover - 8mm x 30

Nut - 7mm Jam

Seal Set - 5 Engines Seal ROLF

Main Jet - SH / Pilot PH - 106: SH1/20

Engine Mount (Silent Block) - Large
Ser 3 Special/TV/SX/GP - TUTTO (Sold in
Pairs Only)

Grand total: $188.12

Note: I spoke with Gene M. Tutto used a "blue" mark for TV and "yellow" for GP on engine mounts. Tutto says they used different hardnesses for the rubber in these two mounts, but Gene questioned if Innocenti really went through this hoop on the stock mounts. He and other reputable shops have used the GP mounts on Li/SX/TV and had great results.

No comments: