The Vision (for when all is said and done)

In speaking with Stu I decided to use an R1/R6 shock conversion for my rear shock. He sent me to Lambretta Club of America (lambretta.org) where a group of guys were going in on a bulk order of shock springs and bushings for the conversion.

Wow! I'd first like to say that the folks in this club are so nice and helpful. These guys offer solutions and share information. The guy, Jake, who placed the order for the springs and bushings not only fronted the cash for everybody, he even drove from San Mateo to SF to deliver my parts to my dad's office. Seriously, good people at the Lambretta Club of America!

Sorry I digress . . .

While perusing the rest of the site I found a section on the "forums" where folks post pictures of their Lambretta's and I came across a 1962 Lambretta TV175 restored to Stone White with a Ox red seat . . . it is exactly the same bike that I have and I have decided to restore it to its original color as well as reuse my red seat. Looking at these photos of this Lambretta is basically like looking at my bike after the restoration is complete.

The bike first looked like this. It was restored by Mike Anhalt, a member of Lambretta Club of America. His post said, "Fully redone TV175 with a GT186, 24mm mikuni, Casa Exhaust. All stainless hardware and proper stickers with orgional floor board extentions. Took about 7 months start to finish (50 hours of 2 hour weekends and mornings)."

Mike wrote the bike was an East Coast rust scoot when he first got it. He was hired by someone to restore it as if Mike was restoring it for himself.

The bike looks a little rougher than my bike, but then again it was 100% complete when Mike received it -- as far as I can tell from the photos.

The beauty in this bike is in the details, I believe. It is clear to me that Mike Anhalt is an experienced restorer and has the eye-of-a-jeweler -- all the small details matter to him. That is the mark of a true restorer. Notice the R1/R6 shock conversion, not stock, but an inexpensive way to build a performance rear shock. I will also build a R1 shock for my TV.

At first I thought that all white scooters were a bit of bore, but with the ox blood red seat the bike really pops. Furthermore, the idea of having the bike look nearly exact the way it did coming out of the factory over 40 years ago seems very cool to me.

I will not add a GT badge on my Lammy, but I will use a Dean's Speed 190 kit so performance wise it may not be different than the 186 kit Mike put on the top end of this TV.

All in all my bike will look pretty similar and also be very mildly customed. My goal, like Mike, is to keep the TV as true to the era.

If bike comes out anything like the one above, I will be so happy.